CornerLock Corner Clamps - Closeout

Not the Cheesy Plastic Clamp You've Seen on the Internet!

The steel square jaw on the inside of the CornerLock is mounted on a slide. This allows you to work with stock of different thicknesses…up to 1/4" of variation. The jaw automatically slides over to compensate for the difference. You get even pressure on both the thick and thin pieces. 

Standard CornerLocks work with material from 1/2" to 7/8". If you work with a lot of thinner material, you can get an optional set of larger alignment pins. These larger pins give you a solid grip on material as thin as 1/4" while still allowing you to grip 3/4" stock. It takes just seconds to change from the standard alignment pins to the thin stock pins. 

Of course, nothing says you can only use CornerLocks on corners. They'll work in the middle of a board, too. Align shelves in a cabinet wherever you want them. Play with the spacing all you want with CornerLocks holding the shelf in place while you and your significant other decide on just the right spacing. 

Unlike lightweight plastic versions you may have seen on the internet, CornerLocks are built from steel and aircraft-grade aluminum. Each tool is individually formed on our computerized press brake, not molded by the millions. The reference surface isn't a spongy rubber pad, it's a precision-machined anodized aluminum cylinder. This is a tool that will be used on every project, instead of being lost in the back of a drawer.

Like all Woodpeckers products, CornerLocks are precisely machined and carefully inspected in our Strongsville, Ohio, facility just south of Cleveland.

WARNING! This product can expose you to chemicals, including chromium, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov